SR. No

POSITION

SALARY (SAR)

DESCRIPTION

1

Estimation and Design Engineer

Negotiable

•Degree In Electrical Engineering.
•Candidate must have experience in Electrical designing calculation for correct selection/sizing of components like CB/Cable etc.
•Should have knowledge of Designing of electrical power & control Panel Boards. Coordinate with Quality control department to take corrective action for any deviation & nonconformity occurred from time to time.

2

Quality Controller

Negotiable

 •Bachelor’s Degree or Diploma in Electrical Engineering.
•Minimum 3–5 years of experience in panel board manufacturing/testing (LV/MV switchgear preferred).
•Strong knowledge of IEC standards (IEC 61439, IEC 62271, etc.).
•Familiarity with protection relays, PLC panels, MCC panels, PCC panels, and control panels.
•Should have knowledge for Deepsea Controller, Zileo Relay, Oden, Freja ,Omicron, ATS Synchronizing module, Transformer Testing (Stability & During), SCADA Signal Testing.

3

Busbar Technician

Negotiable

• Diploma or High School.
• Must have experience as busbar assembly Technician.

4

Panel Board Technician

Negotiable

•Diploma or High School. Candidate must have experience in Panel Installation.
•Able to read Drawing. Should have knowledge of DB dressing. candidate must have experience in below company. AL Fanar, QITAF Factory, Al Amal, Tamimi Panel Board Factory, Wescosa, Rawabi Electric,GES Factory (Abdulkarim Group),EEIC (Abunayyan Group), AL Shuwayer Factory, Al Mina, East and West, MOTS, Arabian Point 8, NOOR, Power Center, Selco .